A curated set of short training videos to help you master everyday MillBox workflows. Start with Crown and Bridge, then move into Screw-Retained and Strategy Editor when you are ready.
Crown and Bridge Workflow
Video 1: Crown and Bridge in MillBox
In this walkthrough, Michael Webb shows the full CAM flow for single units and bridges. Follow along to see where each tool lives in the UI and how to keep nesting fast and clean.
You will learn
- Best practice import and orientation
- Smart pinning and connector placement
- Toolpath preview and simulation checks
- Simple fixes for common nesting issues
Video 2: Crown and Bridge Tips and Tricks
Builds on the first video with time-saving ideas that make nesting easier and more consistent.
You will learn
- Faster selection and multi-part edits
- Queue management and file organization
- Practical tips for reliable outputs
Screw-Retained Cases
Screw-Retained Workflow Overview
Covers MillBox’s approach for screw-retained cases including All-on-X, special screw seats and angled channels.
You will learn
- Object type selection for screw-retained designs
- Setting and verifying the cavity axis
- Seat geometry and access alignment checks
Strategy Editor
Intro to Strategy Editor
Strategy Editor lets you adjust strategy templates and cutting parameters for your machine and toolset.
You will learn
- Where to find and duplicate a base strategy
- Safe edits for feeds, passes and stepdowns
- How to test changes on a sample before production
Note: Strategy Editor is part of MillBox Expert. If you cannot open these settings, contact Level Up Support to enable a trial or upgrade your dongle.
Email: support@levelupcadcam.com
Hybrid Abutment and Screw-Retained
Hybrid Abutment and Screw-Retained Workflow
Alex from CIMsystem explains key requirements and steps for reliable hybrid abutments and screw-retained restorations.
You will learn
- Library and interface selection
- Replace flow tips and verification
- Thickness and connector checks before milling
Special Screw Seats for Implants
Configuring Powerball, Rosen, SegScrew and more
Yago Leal from CIMsystem shows how to configure CAM for custom screw designs and mill them correctly.
You will learn
- Seat definitions and parameter choices
- Strategy implications for each screw type
- Simulation cues that confirm a good setup
Suggested order
- Crown and Bridge in MillBox
- Crown and Bridge Tips and Tricks
- Screw-Retained Workflow Overview
- Hybrid Abutment and Screw-Retained Workflow
- Special Screw Seats for Implants
- Intro to Strategy Editor
Quick checklist
- Latest stable MillBox build installed
- Correct object type selected before nesting
- Simulation run and checked before export
- For Strategy Editor changes, test on a small sample first
Need Further Help?
Still need support? Reach out via our Support Portal or email us at support@levelupcadcam.com.
We’re here to help you Level Up.